GDO-8 Instruction Manual
12
14. Coding a Transmitter
Storing the Transmitter Code
The opener can only operated from remote control transmitters
that have been programmed into its memory. Up to 64 codes
can be stored in the memory.
a. Press and hold the DOOR CODE button.
b. Press Button 1 on the transmitter for two seconds. Release
and pause for two seconds. Press the Button 1 again for two
seconds.
c. Release the DOOR CODE button. The transmitter button is
now coded, press to test.
Coding a Transmitter Button to Enable Vacation Mode
The opener can be programmed into a “Vacation Mode” where
the opener will not respond to any transmitter except the button
of the transmitter that was programmed for vacation mode.
d. Briefly press the DOOR CODE button once, then press it
again and hold (will beep two times on second press).
e. Press one of the four (4) buttons on the transmitter for two
(2) seconds, pause for two (2) seconds, then press the same
button again for two (2) seconds.
f. Release DOOR CODE button.
g. Press and hold the transmitter button for six (6) seconds to
set Vacation Mode. The door code LED will stay lit while
Vacation Mode is active.
h. To reset Vacation Mode, press the same button for two
seconds.
Coding a Transmitter to the Courtesy Light
The transmitter can be programmed to operate the courtesy
light on the opener independently of the door moving.
a. Press and hold the LIGHT CODE button.
b. Press one of the four buttons on the transmitter for two (2)
seconds, pause for two (2) seconds, then press the same
button again for two (2) seconds.
c. Release the LIGHT CODE button.
d. Press the transmitter button to test.
Button 1
IMPORTANT NOTE: Only
TrioCode
TM
128
Technology Transmitters are compatible
with these GDO-8 products.
