Automatic Technology GDO-2 SecuraLift, Installation Instructions Manual

Page: 16 / 24

CODING TRANSMITTERS
16
STEP 18
SETTING TRANSMITTERS CODES
Make sure to connect the battery to the transmitters. The
memory in the openers receiver can store up to 23 different
remote control transmitters.
18.1 STORING THE TRANSMITTERS CODE
1. Press and hold the Door Code button ( Fig. 24 ).
2. Press the button (one of four) on the transmitter you would
like to use to control the door for two seconds, pause for two
seconds. Press the same button again on the transmitter for two
seconds.
3. Release the Door Code button.
4. Press the transmitter button to test if it operates the door.
18.2. SETTING THE TRANSMITTER
TO OPERATE THE COURTESY LIGHT
The transmitter can be programmed to operate the courtesy
light on the door opener.
1. Press and hold Light Code button ( Fig. 25 ).
2. Press the button on the transmitter you would like to use to
switch on the light for two seconds, pause for two seconds.
Press the same button again on the transmitter for two seconds.
3. Release all buttons to store the transmitter in memory.
4. Press the transmitter button to test if it switches on the light.
18.3. SETTING THE TRANSMITTER
TO OPERATE PET (PEDESTRIAN) MODE
1. Press and hold Door Code button and the Close button
( FIG. 26 ).
2. Press the button on the transmitter you would like to use to
control pedestrian mode for two seconds, pause for two
seconds. Press the same button again on the transmitter for two
seconds.
3. Release all buttons to store the transmitter in memory.
4. Press the transmitter button to test if it operates the
pedestrian mode.
To change the default pet (pedestrian) door opening position,
refer step 24 on page 19.
18.4. SETTING THE TRANSMITTER
TO OPERATE VACATION MODE
1. Press and hold Light Code button and the Close button
( Fig. 26 ).
2. Press the button on the transmitter you would like to use to
control vacation mode for two seconds, pause for two seconds.
Press the same button again on the transmitter for two seconds.
3. Release all buttons to store the transmitter in memory.
4. To test, press and hold the transmitter button set for vacation
mode for five seconds to set Vacation Mode.
To reset Vacation Mode press the same button for two seconds.
Please note that when vacation mode is activated all stored
transmitters will be locked out. This mode can only be
deactivated by a transmitter which has being stored to
activate this mode.
FIG. 24
FIG. 25
FIG. 26