p. 9
/11
TL2-QSG-EN-03
SW4
SW6
SW2
SW3
SW5
Fig. 9 Push button for programming
2 sec.
2 sec.
2 sec.
1
2
3
2 sec.
4
2 sec.
1
2
4
3
In standby condition and controlled mode, the Up (SW4) and Down (SW5) buttons can be used to deliver passages
authorization respectively in A or B directions. This feature will be appreciated by the technician in charge of
maintenance or diagnostic job. If the dropping arm option is installed, the Right button (SW3) allows to make a test;
the arm in the horizontal position will drop. Please down load the AS1635 technical manual for more details.
5.9. MAINTENANCE OF SURFACES
To retain the surface appearance and avoid any oxidation deposits or marks, it is strongly recommended to regularly
treat the stainless steel surface with a product specially designed for this purpose.
Automatic
Systems
can provide an approved product under reference -/6031/000.
Automatic
Systems
reserves the right to deny warranty coverage in the case of an apparent lack of maintenance.
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose
other than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic
Systems. The document is subject to change without notice
.
