Automatic Products PREMIER 937 SATELLITE, Setup And Installation Manual

Page: 17 / 49

Installation
937 Series 0208 1.08
Product Pushers
Included with the machine are enough pushers for
you to install a pusher on each candy spiral. This
plastic part is designed to push the top of the
product forward while it is vending, helping it fall
from the shelf. It can also be used with products
that have the wrapper end flap on the outside of
the package. In this case, the pusher prevents
these products from hanging on the spiral by
spreading the flap. The pusher should be installed
at approximately the 1 o’clock position on the
spiral with the tab extending forward (see Figure
7). Locate the pusher in its proper position, hold it
against the spiral wire and push the semi-circular
part around the spiral wire. Black pushers (part
#440215) are used on left hand spirals and white
pushers (part #440141-1) are used on right hand
spirals. Note: Not every selection spiral will need a
product pusher. (Example - Box Items.)
Bagged or Boxed Items
Vending small bagged items in the 8-selection
shelves if not loaded properly could be a problem.
The sealed edge of the bag may get under the
spiral wire causing the product to hang up after it
has been vended. It is recommended that the
lower edge of these types of product be folded
forward and up (see Figure 8) next to the product
before inserting into the spiral space. It is also
recommended to use a slightly larger count spiral
for bagged items because of the product settling to
the bottom of the package.
Cigarette Vending from the 937 Series
Cigarettes can be vended from the candy shelves
using a (15 capacity) spiral for the soft pack regular,
king, 100 MM or 120 MM packs. A (12 capacity)
spiral should be used for (box) packs.
Lock Product Shelves
When all of the product has been loaded be sure all
shelves are returned to their vend position behind the
front roller guide.
Cleaning
The 937 series will do the best merchandising job for
you if it is kept clean. The display window can be
cleaned with any good glass cleaner. The exterior
and interior surfaces should be cleaned with warm
water and mild detergent. Rinse thoroughly and dry
all surfaces.
CAUTION:
Do not use any cleaners containing silicon
as this could cause electrical failures.
The main product shelves can be best cleaned with
the spirals and product spacers removed. Refer to
page 1.04 for removal of spirals and removal of the
product spacers.
Figure 8: Fold bagged items bottom edge
forward and up.
Figure 7: Location of product pusher on
spiral.
V2.3