INSTRUCTION MANUAL COMMERCIAL 2 CHARGING STATION
13
In the charging mode, it displays information about the charging power in kW*h and the
percentage of the car battery charge.
The modes and operation of the charging station on the LCD display depend on the
software version and may vary from version to version.
THE FIRST CONNECTION TO BE MADE IS THE GROUND WIRE TO THE GROUND
BUSBAR MARKED «PE». DO NOT SWITCH ON THE CHARGER WITHOUT A CONNECTED
GROUNDING!
Non-compliance with this requirement may result in the energizing the charger body, electric
shock damage to the service personnel and consumers, as well as in a failure of the charger.
To switch on the externally controlled charging station, a SIM card of the mobile network
operator must be installed in the GSM modem.
Next, the power cable must be connected to the AC mains using external switching devices.
The charging station operation modes are presented on the LCD display, which, among other
things, displays the following information: operation modes (ready for charging, car battery
charge), software and firmware version, station number, GSM network status (signal strength,
network status), vehicle authorization process.
AutoEnterprise
#1 : Charging
V:2.02.1669
0.5 kW*h
M006335
24%
4.4 STORAGE
Store the charger in a sealed container until it is assembled and installed.
Charging station storage conditions:
• The storage area should be dry, free of dust, caustic materials, vapours and combustible materials.
• Store in a storage room with appropriate weather protection.
• Do not expose the charger to impacts..
Storage conditions:
• Storage Temperature: 0 to +40 ° C (32 to 104 ° F)
• Relative humidity: max. 85%
• Avoid extreme temperature fluctuations
• If stored for a long time, check the general condition of all parts and packaging regularly
