20036 - 20038 Page 5
Page 4 20036 - 20038
!! WARNING !!
If you are working on a newer car, you may notice bright yellow tubes or
harnesses underneath the steering column area. These are the “SRS” or AIR
BAG wires. DO NOT tamper with these wires in any way, since this could
result in personal injury and/or damage to the air bag system.
Battery gases are explosive. Do not smoke while working near the car’s
battery.
!! CAUTION !!
When fishing wires through the car’s firewall, be sure to protect them from
sharp metal edges and from hot surfaces on the engine.
NOTE: Some installers hook a battery charger up to the vehicle’s battery
during the installation. This is fine, but it must be removed before running
the vehicle under remote car starter control.
INSTALLATION INSTRUCTIONS
1
BEFORE YOU START
Take this time to read through the entire installation manual. Reading
the manual now will save significant time in the long run.
ALL STEPS
ARE CRITICAL.
The installation information section or our web site
www.designtech-
intl.com
is available 24 hours/day to provide you with up to date vehicle
wiring information for your particular vehicle if needed.
Wire Harnesses:
Always check your wire harness before installing to
make sure that it matches the list/drawing on page 4 of the manual. You
can use the
BLUE WIRE COLOR SHEET
to help determine the col-
ors of the wires in your vehicle -- but be sure to always check these using
a volt-meter since vehicle wire colors can change from year to year in
vehicles.
When you have read the entire manual, and paid close attention to every
step, start the installation by putting the Yellow
WARNING STICKER
under the hood. Pick a surface that is readily visible with the hood open
and will not be easily covered with grime. Make sure that the surface is
clean and grime free before applying the sticker.
Color
Function
Type
Required
Thick Pink
Power(+12V)
Yes
Thick White
Accessory
Relay output
Yes
Thick Yellow Starter
Relay output
Yes
Thick Blue
Ignition 1
Relay output
Yes
Thick Green
Ignition 2
Relay output
Maybe - Consult Wiring Guide
Black
Ground
Yes
Color
Function
Type
Required
Red/Black Diesel “wait to start”
Input (+/-)
No
Red/White Remote Input
Input (-)
No
Green
Tach
Input
No
Violet
Hood
Input (-)
Yes
Orange
Brake
Input (+)
Yes
Color
Function
Type
Required
Yellow
Lights
Relay output No
Blue
Horn
Relay output No
Brown
Acc. Pulse/Dome Light Output (-)
No
Brown/White
Alarm Disable
Output (-)
Maybe
White/Black
Ignition 3
Output (-)
No
Color
Function
Type
Required
Gray
Alarm Trigger
Input (-)
No
White
Ground out while armed Output (-)
No
Green/White
Trunk / Carburetor
Output (-)
No
Gray/Black
Door Pin Switch
Input (-)
No
Color
Function
Type
Required
White/Red
Lock Common
Relay output
No
Yellow/Green Unlock Normally Closed Relay output
No
White/Green
Lock Normally Closed
Relay output
No
Yellow/Red
Unlock Common
Relay output
No
Plug In Switch
Plug In LED
AutoCommand Wire Harness
Optional Shock Sensor Jack
For vehicle specific wiring information -- consult the Blue Sheet
for general information and consult our Web sit for more specific
information.
www.designtech-intl.com
.
