Change room temperature
•
Select icon in menu bar (3) with rotary push button.
•
Change by tapping in the setting level.
•
Depending on the appliance that is connected, select between heating system
(HEATER) or air conditioning system (AC) or automatic air conditioning system
1
(AUTO)
using the rotary push button.
•
Tap rotary push button to confirm selection.
•
Select desired temperature with rotary push button.
•
Tap the rotary push button to confirm the value.
Heater (HEATER)
•
settable temperature range 5 – 30 °C (1 °C steps)
•
a = Heater
2
– Heater is switched on.
Air conditioning system (AC)
•
settable temperature range 16 – 31 °C (1 °C steps)
•
b = COOL * – Air conditioning system is switched on
•
c = AUTO – Air conditioning system is set to automatic
•
d = HOT – Air conditioning system is in heating mode.
•
e = VENT – Air conditioning system is in air circulation mode
Automatic air-conditioning system (AUTO)
Settable temperature range 18 – 25 °C (1 °C steps)
Automatic switch-over between heater and air conditioning system for an approximately
constant temperature on the inside.
f = AUTO – Automatic air-conditioning system is activated
Requirements for operation with automatic air-conditioning system:
•
The heater and air conditioning system must be connected.
•
Automatic air-conditioning system “ACC” must be activated in the service menu (see
“Service menu” on page 13).
Interior Climate Control
The following menu options allow you to set the room temperature in your Auto-Sleeper
motorhome simply and conviniently. If you have a Truma air conditioner and a Combi
heater, the automatic climate control function controls the temperature in the vehicle –
regardless of the outside temperature.
34
Harmony - Changing Room Temperature
Harmony User Guide - Introduction
035
Harmony - Changing Room Temperature
35
Changing Room
Temperature
Note:
Quick temperature
change using rotary
push button possible
(in Stand-by screen).
1
Automatic air conditioning system (AUTO) only if “ACC” has been activated in the service menu (see
“Service menu” on page 13). This is deactivated at the factory.
2
Symbol flashes until the desired room temperature is reached.
