20
5
PRINTING TEST RESULTS
After a test is made with the BVA-230OZR make sure the
results are displayed on the LCD.
Point the BVA-230OZR in the direction of the IR Receiver
(within 15 ft.)
Press the <Print> key and the test results will be printed.
Depending upon the test made the printer will sometimes yield
more information than the LCD.
Point the BVA-230OZR IR Transmitter in the direction of the IR Receiver.
Press (Print). You should be within 15 ft. of the IR Receiver. Wait for the
screen to clear before moving the BVA-230OZR. It takes a moment to
send all the test data.
INSPECTION
Valid automotive electrical system testing depends on
all the components being in good operating condition.
In addition, the battery MUST have sufficient charge
for testing. Carefully perform the following steps
before attempting any electrical diagnosis.
VISUAL CHECK
Inspect Belts
for cracks, glazed surface and
fraying. Customer should tighten loose belts.
Inspect Battery
for
terminal corrosion, loose
or broken posts, cracks
in the case, loose hold-
downs, moisture, and dirt
around the terminals.
Inspect Starting System.
Check starter, solenoid, and regulator for loose
connections, loose mounts and frayed or cracked wires.
Important Note:
A damaged battery must be replaced before proceeding.
