27
© 2012 Directed. All rights reserved.
Trigger Zone Fault Report
When armed by remote command the system runs a status check of
the alarm trigger zones. Faulty zones (usually caused by dome light
delay or open trunk) are bypassed and reported via the control center
LED and remote, while all other trigger zones remain active and are
monitored to protect the vehicle. Should a faulty zone self correct
(dome light turns off) it becomes active and is then monitored normally.
The siren chirps once again a few seconds following the arming
chirps as an audible alert, the control center LED flashes in groups to
indicate the zone number. The remote will emit a single fault tone and
play zone specific text that identifies the faulty zones.
Alarm Report when Disarming
The most recent alarm triggers (if any) are reported when the alarm is
disarmed via the remote control, siren chirps, parking light and control
center LED flashes. The siren chirps 4 times (or 5 times if NPC on*),
the parking lights flash 3 times, and the control center LED flashes in
groups to indicate the last two zones that were triggered (see
Table
of Zones
). The
DISARM
text is replaced by
ALARM REPORT
and text
identifying the triggers. The report output will repeat for each disarm
operation until the vehicle is driven.
* See
“Nuisance Prevention (NPC)” on page 28
.
