28
Manually Lighting the Grill
To reduce the risk of serious bodily injury or death from fire or explosion:
• Open Hood before lighting the grill to prevent an explosion from gas build-up.
WARNING
!
1. Open the Hood.
2.
IMPORTANT:
Make sure Control Knobs are turned “Off.” (Fig. 4 - P.27)
3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 5- P.27)
4. Locate match-lighting hole at the right end of the Grill Bowl. Push in and turn the far right Main Burner Control
Knob, near the match-lighting hole, counterclockwise to the “High” position.
5. Insert a lit match through the match-lighting hole (Fig. 7)
6. From the “Off” position, light all other Burners, making sure each Burner is lit before lighting the next. Your grill
has a Crossover Ignition System that allows the Burners to light successively off one another. Confirm each Burner
is lit before lighting another Burner.
If any or all Burners fail to light after three or four attempts following Steps 3-4, turn all Control Knobs to the “Off” po-
sition and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting
procedures.
NOTE:
If the Burner still fails to light, refer to the
Troubleshooting Section.
7. After ignition, turn the Control Knobs to “High” for 3-5 minutes and close the Hood to preheat the grill. Preheat the
grill before every cooking session.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve
to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.
Insert lit match
through matchlighting
hole under the right
side table.
Fig. 7
