2.
CARING FOR YOUR TONNEAU
Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's
waterproofing ability and prevent the stitching from degrading. Use a mild detergent and soft
scrubbing brush to clean tonneau.
Never drive without tonneau support bars in place as flapping can cause a delaminating effect on the
material.
"Tonneau is not designed to be used as a load restraint"
3.
MULTI-FITT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from
Suburu Brumbys to Cab Chassis aluminium trays.
3.1 BASIC TOOL REQUIRED
Drill, 4mm drill bit
3.2 MULTI SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
3.3
FITTING MULTI SUPPORT BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket
holders with the holes facing to the ground (so the grub screws don’t rub against the tonneau),
as shown above and then with a white pencil make a mark through the small holes of the
hollow bar onto the solid ends. This is where you will drill a hole to the depth of about 1-2mm
(do not go any further)
2.
Join the pieces back together and screw grub screws through the hollow bar into the holes
that you drilled. Make sure you do not over tighten the grub screws. Refit the bar. You may
kink the bar in the middle to give it some extra height to assist with water runoff.
4.
WARRANTY AND FEED BACK
Register now to activate your 3 year warranty by filling out our online form!
QR Code:
Website Link
:
http://www.aussietonneaus.com.au/en-au/warranty-card-request-form.html
Please complete our 2 minute feedback section as we strive to constantly improve for
our customers
.
Thank you for purchasing an Aussie Tonneaus Product.
