WORK SMART
…
STAY SAFE
|
Aussie Scud Mine Boss (Class A)
…
Operator
’
s Instruction Manual
10
Aussie Pumps
Jan 2019
FAULT
CAUSE
REMEDY
Pump running normally but
pressure low on installation
Pump sucking air
Valves sticking
Unloader valve seat faulty
Nozzle incorrectly sized
Worn piston packing
Check water supply & possibility of air ingress.
Check & clean or replace if necessary
Check & replace
Check & replace
Check & replace
Fluctuating Pressure
Valves worn
Valves blocked
Pump sucking air
Worn piston packing
Check & replace
Check & replace
Check water supply & air ingress at joints in suction line
Check & replace
Pressure low after period of
normal use
Nozzle worn
Check valves worn
Check valves blocked
Unloader valve seat worn
Worn piston packing
Pistons cracked as a result of dry running
Check & replace
Check & replace
Check & clean
Check & replace
Check & replace
Replace pistons
Pump Noisy
Air in suction
Broken or weak suction or delivery valve
spring
Foreign matter in valves
Worn bearing
Excessive temperature of liquid
Check water supply & connections on suction line
Check & replace
Check & clean
Check & replace
Reduce temperature
Presence of water in oil
Oil seal worn
High humidity in air
Piston packing worn
Check & replace
Check & change oil twice as often
Check & replace
Water dripping below pump
Safety valve activated due to pressure
spike
Thermal dump activated
Piston packing worn
O.R plunger retainer worn
Reset safety valve (see page 13), if it keeps activating
replace unloader
Activates if water temperature exceeds 60°C. Should
self reset once water in pump cools. If not, replace
Check & replace
Check & replace
Oil Dripping
Travel plug in use on pump
Oil seal worn
Replace with breather plug
Check & replace if necessary
Unloader switches
repeatedly when gun is off
Leaking gun &/or pressure pipe.
Leaky sleeve
Worn out kick
-
back valve body
Leaky seals
Renew gun, seal pressure pipe
Renew sleeve
Check & renew as necessary kick
-
back valve plate & seat
Renew seals
Leaky piston rod
Defective O
-
Ring/Support Ring
Renew piston rod seals & examine surfaces in guide
case
Leaky by
-
pass at nominal
pressure
Nozzle too small, too much water.
Worn out by
-
pass valves
Install larger nozzle
Examine & renew as necessary
Pressure gauge shows high
pressure fluctuations when
shutting off gun
Valve set too high above operating
pressure
Dirty valve
Adjust the unloader at the operating pressure.
Clean valve (removing lime deposits etc).
Grease parts before installing.
Pressure in supply line when
running on by
-
pass
Dirty or worn low pressure valves
Remove & clean or replace low pressure valves
Engine will not start
Out of fuel
Engine defect
Fill tank with petrol/diesel
Return to engine service agent
TROUBLE SHOOTING GUIDE
(for engine troubleshooting refer to engine manual)
