AC
-R2-001
Page 7
WARNING! It may hazardous to use the wrong type of regulator.
Storage of Appliance
Always wait for the appliance to cool down before attempting to transport or store. Storage of an appliance
for transport or indoors is only permissible if the cylinder is disconnected and removed from the appliance.
When the appliance is not being used for a period of time it should be stored in a dry dust free environment.
INSTALLATION
1. Open carton and take out the appliance (CAUTION: VERY HEAVY! SHOULD BE LIFTED BY TWO
PEOPLE). Check carefully for any damage on the appliance; call your dealer if damage occurred. DO
NOT install damaged appliance.
2. Find a well ventilated and level place to install the appliance. The appliance is fitted with 4 adjustable
legs. Place the appliance on a flat base and adjust legs to maintain a level cooking surface.
3. A LOW PRESSURE regulator MUST BE used with this the appliance. (Details refer to Regulator in the
“PREPARE TO ASSEMBLE THE APPLIANCE” section)
4. The gas inlet is located at the rear right hand side of the appliance. The gas inlet fitting is ½” BSPF for
Natural Gas Model and CGA-510 POL with Soft Nose for LPG Model.
5. Connect the gas inlet to the main gas supply in accordance to Australia Standard. If a flexible hose is to be
used, DO NOT assemble beneath the appliance, under direct sunlight or close to other sources of heat.
6. The length of connection between the appliance and the main gas supply should not exceed 1.8m.
7. Check for gas leakage at all joints with soapy water or other approved methods.
UNDER NO CIRCUMSTANCES SHOULD A NAKED FLAME
BE USED IN CHECKING FOR GAS LEAKS.
OPERATING INSTRUCTIONS
Ignite the Burner
1. Ensure the Control Handle (C) is at ‘OFF’ position.
2. Turn on the main gas supply.
3. Press and Hold Switch (A) down.
4. Press Switch (B) down, to ignite the pilot flame. Release Switch (B)
5. Repeat Step 4 until the pilot flame is alight.
6. Continue to hold down Switch (A) for 10 second, and then release.
7. Repeat Step 1 – 6 if pilot fails to stay alight.
8. Turn Handle (C) to ‘ON’ position.
Turn off Burner
1. Turn Control Handle (B) to ‘OFF’ position.
2. Turn off main gas supply.
ABNORMAL OPERATION
You should cease using the appliance and seek service from an authorised agent if any of the following are
observed during operation of the appliance:
Carbon Build up on the appliance or pans,
Excessive yellow tipping of the burner flame,
Flame lifting off the burner ports or flashing back.
Flame abnormality may be due to gas supply restriction or blockage of burner ports or venturi. Gas spillage
may occur if the burner inlet is partially blocked. The gas may ignite around the burner inlet.
Summary of Contents for Y018LPWF-S
Page 11: ...AC R2 001 Page 11 ...
