USERS GUIDE
www.auroramm.com
10
Front Connections
•
Dual Type-A USB 2.0:
USB 2.0 connectors. Units USB Device LED must be lit for it to function
properly with remote end. Can also be used to charge devices.
•
IR OUT:
Plug the IR emitter into this port and affix onto the device where its IR window is located.
•
IR IN:
Plug the IR receiver into this port. The front built in IR receiver will no longer work once the
external receiver is plugged in. Note this port should be used with Aurora IR receiver model as other
brands may not follow the correct pinout or voltage.
•
IR:
IR receiver capable of 32KHz to 60KHz range.
Rear Connections
•
48V DC:
Power connector for 25-watt 48VDC power supply (PS0094-3-S).
Note: Only 1 supply is required to power both units. Either side can send power to the other unit.
Note: If LAN PoE+ is utilized the 48VDC supply is not required.
•
RS-232:
Connect RS-232 device up to 115k baud.
•
LAN1/2:
1Gbps LAN connection. LAN1 can use PoE or PoE+ from a PoE switch to power both the RX
and TX units. PoE+ is highly recommended if Dante or USB is utilized.
•
HDBaseT:
Connect CAT 5e/6/7 cable. Shielded cable is not necessary unless the environment has a
lot of electrically noise.
•
HDMI Input 1-4:
Plug HDMI cable from source device like a Blu-ray player. Source can be selected
from RS-232, Ethernet, Auto Sense Mode, or front buttons.
•
HDMI Output:
Plug HDMI cable from device like a LCD monitor.
Note: The HDMI cable should be rated for the bandwidth you are using.
•
Audio Line In/Out:
Euro Style connector for stereo line in and line out.
•
USB 2.0 Host:
Type-C USB 2.0 Connector for connection to PC. Unit must be set for Host mode for it
to properly operate.
*Note: Some POE switches do not supply the full 15.4watts per port. Verify the total power rating of the
switch. It should be at least 15.4W x (number of ports) and ideally 25.4W (PoE+) per port if USB
peripherals are to be utilized and/or Dante option card.
Option Port
Inside the unit there is an option card connector for the Dante 2ch or 8ch option or the ReAX control system
option. Only one of the cards can be installed into a unit. To access the port, power off unit and the 4 screws (2
on each side) must be removed. Take the cover off and insert the card in the proper orientation as indicated on
the circuit board. Put cover back on and apply power. Don’t forget to note the MAC address of the card to
identify which unit it is in.
