4
User Guide
Rear Panel DXP-62
1
Audio Input
2 HDMI audio & 2 VGA audio inputs. User can choose any one audio
(embedded HDMI audio or external input audio) for HDMI audio input
by using RS232 commands.
2
Audio
Output
Audio output port, the audio comes from the input audio corresponding
to the selected video source and mixed with MIC audio.
3
IR Out
Connects with IR emitter, used to control local source device or the
DXP-62 from remote, switches following the corresponding video
source.
4
IR In
Connects with IR receiver (with carrier wave only), to receive IR signal
send by the IR remote or remote controller of other input or output
device.
5
Firmware
USB port, connects with USB flash disk or other storage which is with
update file inside, to update the system firmware.
6
RS232
Serial control port, 3p captive screw connector, connects with a control
device (such as a computer) to control the DXP-62 or other device
connected with the HDMI twisted pair PoH receiver.
7
12V DC
Power port. Connects with the 12V DC power adapter.
8
Mic
8A. MIC port, connects with microphone.
8B. 3-position switch: 48V phantom power mode (connects with
condenser microphone), MIC mode (connects with dynamic
microphone) and LINE mode (connects with wireless microphone or
line audio).
9
Video Input
Video input ports, includes 4 HDMI inputs & 2 VGA inputs. VGA ports
supports YPbPr, Composite Video and VGA format. Factory default is
VGA format.
10
Output
10A. HDMI local output. 10B. HDBaseT output. The audio part of the
two ports are same, and is mixed with MIC audio and HDMI embedded
audio (output audio), and if disable HDMI embedded audio output, then
there will be no audio output through these ports.
