Aurora Archer IS007, Installation & Operating Instructions Manual, Page: 22 / 44

OPTIONAL REMOTE CONTROL THERMOSTAT
21
Operator Switches
Economy Display Mode Button
Front Burner Rear Burner
An optional programmable Remote Control Thermostat can be fitted to the heater at the factory when
ordered or even after the heater has been installed. See your Archer dealer for correct type.
Installation:
The Remote Control can be installed by the owner of the heater if required. The Remote
Control is a battery operated device, which requires a small amount of low voltage plug in wiring. A
wiring loom package is supplied by Aurora Climate Systems, which simply plugs onto the front panel
and the red button. Refer Page 22.
Remote Control Operation/Programming:
Refer to the instruction sheet supplied with the device.
Note: Aurora Climate Systems is not the manufacturer of any Remote Control Thermostats and will
charge a service fee to the customer who requires a technician to be on site to give operating
instructions, installation, set up or programming. If the device appears to be faulty it will need to be
posted back to Aurora Climate Systems where the functionality will be checked and returned back to
the customer in working order. Aurora Climate Systems recommends that the customer familiarise
themselves with the Remote Control Thermostat operation through reading the instructions supplied
or by requesting that the installer of the appliance commissions the Remote Control Thermostat.
Economy Display Mode (Red Button Operation):
The red button above the two burner switches is
called the economy display mode and will only function when a Remote Control Thermostat has been
installed in the heater. The most common way this button is used is having the Remote Control set on
the Thermo mode with a desired temperature set for the heater to cut in and out, which will of course
be relevant to the ambient temperature, location and the area the appliance is positioned in. When
using a Remote Control Thermostat both burner switches need to be in the on position. When the red
button is pressed to be illuminated in conjunction with having both burner switches on, the front
burner only will commence ignition and then remain on or if already alight it will now remain on,
regardless of what function or temperature is set on the Remote Control.
In this situation only the back burner will cut in and out according to the setting on the Remote
Control. We believe by running the heater this way you will use less gas and still have the ascetic
affects of the front burner. However if the appliance is in a small area this may get to warm for you.
All you need to do then is press the red button so that it is not illuminated and the heater will then
revert back to its normal operation.
In basic terms the red button acts as a Remote Control override switch for the front burner only. Also
the Remote can switch the heater on and off in the high setting, medium setting or low setting.
Refer Page 31 - Burner Settings.
Note: When the heater or the Remote Control is not being used for long periods the burner switches
should be in the off position, also in summer the heater should be turned off at the power point.
Push inwards at bottom for ON