~ 17 ~
The EDID learning function is only necessary whenever you encounter any display connected to
the HDMI output port that cannot play audio and video properly. Because the HDMI source
devices and displays may have various level of capability in playing audio and video, the general
principle is that the source device will output the lowest standards in audio format and video
resolutions to be commonly acceptable among all HDMI displays. In this case, a 720p stereo
HDMI signal output would be probably the safest choice. Nevertheless, the user can force the
matrix to learn the EDID of the lowest capable HDMI display among others to make sure all
displays are capable to play the HDMI signals normally by performing the procedures stated
below.
SW1-SW8’s Pin 1 must be set to “ON” and left there for EDID
Learning Mode. Turning to “OFF” will return to factory defaults.
Method 1: Use the front panel on the master unit
Button
Function
OUTPUT 1-8
EDID will be read from display from the respective output port
INPUT 1-8
The EDID will be sent to the HDMI source connected to respective HDMI input port
1.
Push
EDID
button to enter EDID learning mode
2.
Select one or multiple
INPUTS 1-8
buttons that you want those input ports to learn
the EDID of the display from certain
OUTPUT
port. The input port is selected when
the LED is on. Push the
INPUT
button again if you want to cancel this input port to
learn EDID.
3.
Select the HDMI display that you want the matrix to learn its EDID by push the
OUTPUT
button connected to this display.
4.
Press the
EDID
button to initiate the EDID learning sequence. If the sequence is
done successfully, the front panel will get back to normal operation mode. If the
sequence is failed, the LED of the chosen input ports will flash then please try again.
DIP Switch Position
Pin 1
Description
ON
[
Æ
]
EDID
Learning
– for learning EDID from the display
EDID Learning
