WIZ2-434
Instruction Manual
Technical features are subject to change without notice. AUR°EL S.p.A does not assume responsibilities for any damage caused by the device’s misuse.
AUR°EL S.p.A.
Via Foro dei Tigli, 4 - 47015 Modigliana [FC] – ITALY Rev. D, 31-01-2003
Tel.: +390546941124 – Fax: +390546941660 Page 8 of 14
http://www.aurel.it
- email:
2.3 MASTER AND SLAVE MODULES: ( SUMMARY)
MASTER
SLAVE
It places the address at the head of the data packet
→
→
RF
No
Yes
It removes the address from the data packet head
→
→
RS232
No
Yes
It verifies the destination address
No
Yes
It verifies the checksum
Yes
Yes
Internal address
0
≠
0
3. Programming
The WIZ2 modules may be programmed through the serial port, by closing the jumper 3 and supplying,
subsequently, the module.
The programming mode foresees to enter a WRITE or READ type command.
Here below is reported the list of the registers, their addresses and functions.
REGISTER’S
NAME
ADDRESS FunCTion
DEFAULT
ADDRESS
$00
WIZ2 module’s address
$00
RS232
$03
RS232 protocol options:
00: no parity
01: odd parity
02: not in use
03: even parity
$00 (no parity)
3.1 WRI TE
The WRITE command enters a value in a register of the microcontroller’s internal EEPROM, contained in the
WIZ2 module.
Format:
#_<address_register>_<value_register>
The programming string is composed by a 3 bytes sequence:
•
‘#’: ASCII type $23 which enables the microcontroller to receive a command of a register writing.
•
<address_register>: is the register’s address to be written
•
<value_register>: is the register’s new value
