AURATON S03 RT, User Manual

Page: 15 / 24

15
In the event of a pairing error, steps 1 and 2 must be repeated. If more
errors occur, all devices must be unpaired by RESETTING the receiver
(see “RESET - Unpairing all devices paired with the receiver”) and then an
attempt must be made to pair the devices again.
NOTE: Only 1 controller may be assigned to one receiver.
Signaling of operation and receipt
of data packets
Each reception of radio transmission from a paired device is indicated by
the AURATON RT receiver by a momentary change of the color of the LED
diodes. After the relay becomes activated, the LED diode is red and after it
is switched off – it is green.
NOTE: When any button is pressed, a short sound signal is emitted.
Unpairing of the controller and the RT receiver
1. Unpairing of the AURATON S03 RT controller from the AURATON RT re -
ceiver is initiated by pressing the left unpairing button ( ) on the receiver
and holding it for at least 3 seconds until the LED diode starts blinking
red – then the button must be released. The sound signal works in the
same way as during pairing, i.e. when a button is pressed, a short sound
is emitted and another short sound signal after 3 seconds.
The receiver waits for unpairing of the device for 120 seconds. After this
period, it automatically returns to normal operation.