1
- Recline adjustment locks into position. To
release press down on lock button. When
installing with the base, additional stability
can be achieved by using the stability leg. For
instructions on using the stability leg when
installing the base, see Stability Leg section.
2
- Route the vehicle belt through the opening in
the base labeled ‘belt here’.
3
- Buckle the vehicle belt. Both the shoulder
AND
lap belt must be under the blue lock off and
belts must lay flat.
4
- While pressing the base into the vehicle seat
(1)
, tighten the vehicle belt by pulling straight
along the belt path
(2)
, keeping both belts
laying flat in the lock off.
5
- While the shoulder belt is tight, hook the
bottom of blue lock off and press to close the
lock off on the shoulder and lap belt.
If vehicle only has a lap belt, then put lap belt
under blue lock off.
Check Installation
Belts must be tight.
Base should not move side to side more than
1” at belt path.
Bubble must be touching line.
Belts and buckles must not interfere with
attachment of child restraint to base.
Vehicle belts must lay flat under lock off.
It is acceptable to install with both LATCH (lower
attachments) and the vehicle belt.
1
2
1
2
3
4
5
36
PIPA instructions
37
PIPA instructions
click
