14
4.
MODES OF OPERATION
This section describes about the modes available for selection in this module. The options are:
MODE 1
- Program mode
MODE 2
- Calibration mode
MODE 3
- Diagnostic mode
There are several options/settings that are available in each of these modes. These are discussed
below.
PROGRAM MODE
4.1
The push buttons on the Front Panel can be used for programming. To enter into PROGRAM MODE,
follow the below steps:
Step 1:
Keep the selector switch in OFF position
Step 2:
Press Open + Close keys together for approximately 6 seconds.
Step 3:
Press the STOP key on the display of “Program Mode” as shown in the below figure.
In the program mode, one can choose to configure settings as per custom requirements. The three
sub-categories are – General settings, Remote settings and Relay settings. The flowcharts to choose
EDIT/VIEW and any one subcategory are given below.
EDIT/VIEW option of PROGRAM MODE
4.1.1
By entering the appropriate password, user can enter into the “
PROGRAM MODE
” for 3.XMP Non
Intrusive with Bluetooth Module as shown in the above flowchart. The features that can be set in this
are given in the below flowchart.
