www.auga.nl
33
Persons who have not read and understood the operating instructions
should not use the pressure filter!
This device is not intended for use by persons or children with physical, sensory
or intellectual impairments, or if lacking in experience and or know-how, unless
they are under supervision or have been trained in the use of the device by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the device.
Intended use
The VarioPress Pro is a pressure filter with built-in UV-C for mechanical and
partial biological filtration of the pond water of standard ponds with temperatures
from +4 º C to 35 º C. The pressure filter is designed for private use for cleaning
garden ponds with or without fish (no koi). A pump is necessary for the operation
of the pressure filter, which pumps the pond water through the pressure filter.
Scope of application:
If there are people in the water, the pressure filter is not allowed to operate!
(disconnect pressure filter from the power supply.)
It may not be used in or near swimming lakes or swimming pools!
Safety instructions
Attention! UV-C radiation is harmful to eyes and skin!
Only use the UV-C lamp of the pressure filter in the closed device.
The operation of the lamp is easy to observe through the
transparent inspection glass.
Warning!
This pressure filter may only be used in ponds if the electrical
system meets relevant statutory requirements.
o
If in doubt, consult a qualified installer.
The pressure filter may only be connected to a system with a
ground-fault circuit interrupter (30 mA) and earthed power
outlet.
The power supply and current type must match the data on the model
tag or as shown in the table on page 2.
The pressure filter must be set up at least 2 meters from the waterfront.
(Refer to illustration 1.)
Place the power outlet in a moisture-free area, at least 2m from the
water's edge (Refer to illustration 1.)
Check the power cord, plug and pressure filter for damage before using
the pressure filter.
Important:
do not use if the cord, plug or pressure filter are damaged.
Go back to the dealer to assess the damage.
Do not move or hang the pressure filter by the power cord.
Keep the plug dry. To prevent water from running from the cord to the
plug, suspend the cord in a U-shape (Refer to illustration 9.)
When working on the pressure filter, always disconnect the pressure
filter and take off the pump outlet connected to the pressure filter, so
that the power supply to the pressure filter and pump is disconnected.
The UV-C lamp of the pressure filter may only be switched on if it is
completely filled with water and if there is an adequate flow of water
through the pressure filter.
English
