128-8261
15 of 24
Page 15
120VAC wall socket and the charging will start. If you have the USB to USB
cable, found on some wall charge units, than you can also connected to a
PC's USB 5 Volt port to charge your transceiver. Additionally if your unit is
packaged with the 12 Volt DC adaptor, you can charge the unit is your vehicle
by connecting to the accessory plug in the vehicle and connecting the USB
mini USB to than to the Transceiver.
While under charge, the display will show the screens shown on the left. If the
OLED screen goes blank,
battery save mode, than by
pressing the transceiver's
side switch will illuminate
the screen indicating the
battery charge status.
MAIN PAGE:
Press the transceiver's side switch to open the main page, the screen will
indicate the last known status of your system. Shown are some of the
screens that may be displayed.
If the display is
flashing,
pressing the
side button
again to
display the details of the flashing screen which is displayed in the following
order, Triggered/Engine Running/Count Down Timer/Timer Start/Alarm Timer
Condition.
If the triggered screen is flashing, pressing the side button will reveal the
triggered zone as shown. If more than one zone was triggered the screens
will be revealed sequentially.
