-7-
re-program the transmitters, repeat the
above procedure.
OPERATING YOUR SYSTEM:
ARMING:
1. Exit your vehicle, and close all entry points.
2. Press button #1 of your keychain transmitter
1 time. The siren will emit a single tone
indicating that the system is armed. The
parking light will flash once and the starter
inhibit relay will be engaged.
NOTE: Pressing the arming button twice
within 3 seconds will allow the unit to
arm without the shock sensor. This
will be indicated by a single chirp tone
followed by a single lower pitch chirp
tone. When operating in this mode,
the only detection means will be the
voltage sensor. The next normal
arming of your system will re-instate
the shock sensor.
Protection While the System is Armed
A. Opening a door (or any light activated entry
point), will cause the alarm to immediately
sound and the parking lights will flash on
and off for the complete 60 second alarm
cycle.
B. Any unauthorized attempt to start the
vehicle will be prevented.
C. Any light impact to the vehicle glass or
body panels will cause the system to
immediately sound the warning chirp,
discouraging any further attempts to
enter the vehicle.
D. Any forceful impact to the vehicle will
cause the system to immediately trigger
for the complete 60 second alarm cycle. At
the end of the cycle, the alarm will re-arm
itself, and resume monitoring the vehicle.
DISARMING:
1. As you approach your vehicle, press button
#1 of your keychain transmitter 1 time. The
siren will emit two chirps indicating that the
system is disarmed. The parking lights will
flash twice and the starter inhibit will be
disengaged. You may now enter and operate
your vehicle in a normal manner.
NOTE: If you heard four chirp tones upon
disarm and the parking lights flash
three times, this indicates that the
system had been triggered in your
absence. Carefully inspect your vehicle
for break in or physical damage.
If your system fails to operate as above:
1. Check and ensure that your keychain
transmitter is operating properly and that
the small LED on the transmitter illuminates
when a transmitter button is depressed.
2. Check and ensure that the Red wire of the
system is connected to a +12 volt battery
source.
3. Be certain that the transmitters are programmed
into your alarm system. If power had been
disconnected from the alarm or the vehicle
main battery had been disconnected, it is
necessary to re-program the transmitters.
See transmitter programming section of this
manual.
Summary of Contents for Rampage AA-939
Page 11: ...11...
