128-6627
7 of 8
Page 7
COMPLETING THE INSTALLATION
After all wire connections have been made, plug the main 14 pin connector into the control module. During the first few
seconds of power up, the circuit's processor learns the resting state of the Red, Red/Black, Green and Green/Black
wires of the 4 pin connector. It is important that the ignition switch be off, and the door lock/unlock switch or transmitter
not be used during the power up sequence. Once this sequence is complete, you can disarm the system with the
customers transmitter and move onto programming the selectable features.
NOTE: This unit has the ability to learn the dome light delay time, up to 60 seconds. If the vehicle has delay interior
lights, and you wish to avoid three chirp, defect zone, indication normally associated with this type of interior light, we
suggest you learn the interior light delay.
To learn the light delay, start with all all doors closed:
(1) Use the transmitter to Lock / Unlock / Lock / Unlock / Lock / Unlock / Lock, the system.
The LED turns on solid to confirm the system entered the learn mode.
(2) Immediately open and close the door of the vehicle to initiate the dome delay.
The unit will monitor the door trigger input Positive, (Purple), and Negative, (Brown) when active.
When the dome light turns off, the unit will add 2 seconds then exit the learn mode.
(3) The LED will begin flashing the Armed indication indicating the unit has exited the learn mode and is armed
