Page 4
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation “chirps” can easily be turned on and off
using the valet toggle switch. To do this....
1. The valet switch must be in the “off” position.
2. Turn the ignition key on, and then off.
3. Within 10 seconds of turning the ignition key off, move the valet toggle switch to on
-off - on - off -on -then off.
4a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps to
indicate that the chirps have been turned off.
Enter the vehicle and observe the dash mounted L.E.D. for further information.
1. If the L.E.D. is flashing one time...pause...one time... etc., then an intrusion attempt
was made to a voltage sensing, light activated entry point.
2. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion attempt
was made to the hood, trunk, or any optional sensors that were added to the vehicle.
3. If the L.E.D. is flashing three times...pause...three times...etc., then an intrusion
attempt was made through one of the vehicles doors.
These intrusion warning indicators are stored in the system’s memory, and will only be
erased from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The “Valet” switch allows you to temporarily bypass all alarm functions, eliminating
the need to hand your transmitter to parking attendants or garage mechanics. When the
system is in the valet mode, all alarm functions are bypassed, however, the remote panic
feature and remote door locks (optional) will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the “on” position.
2. Move the valet toggle switch to the “on” position within 10 seconds of step 1. The
dash mounted L.E.D. will turn on solid, and remain on as long as the system is in
the valet mode.
3. To return to normal operation, move the valet switch to the “off” position any time
the ignition is on.
In the event you lose your transmitter, or if the transmitter fails to disarm the system,
the valet switch can be used as a system override switch. Open the car door (the alarm
WILL
sound). Turn the ignition key on, and move the valet switch to the “on” position
within 10 seconds. The alarm will stop sounding, and the vehicle can now be started.
NOTE:
Always remember to move the Valet Switch back to the ”off” position. This
will ensure that the vehicle remains protected at all times.
