7
VEHICLE PREPARATION:
1) Locate an accessory power source (+12v when key is in the ACC. and run positions,
and 0v when key is off), and also a good ground generally, these wires can be found at
the ignition switch or fuse-box.
2) The mounting method and location will vary from vehicle to vehicle, so this manual will
only focus on the installation of the ADV48 and related console accessories.
3) Generally, the best location for the video monitor is where the vehicle's factory dome
light is installed. The monitor should be located in such a manner that it can be
comfortably viewed by rear seat passengers.
NEVER INSTALL THE MONITOR IN A PLACE WITHIN THE DRIVER'S VIEW. THIS IS
NOT ONLY DANGEROUS, BUT IT IS ALSO ILLEGAL IN MANY STATES.
4) Once the mounting location of the monitor has been determined, there may be
additional preparation work necessary, depending on the vehicle structure and
installation method. Some of the steps that may be required are:
A)
Removal of the vehicle's dome light
B)
If the trim ring will be used, it may have to be trimmed to fit the contour of the
vehicle's headliner. Refer to the "Trim Ring Installation" section in this manual.
