37
7.
Connecting a speaker to the subwoofer out-
put
The
Subwoofer Output
of the M 5.4DSP allows
to connect a passive MATCH Plug & Play sub-
woofer (like the MATCH PP 7E-D or PP 7S-D),
a conventional subwoofer or speaker.
Note:
The Augmented Bass Processing can
also be activated for this output in the standard
signal processing concept of the DSP PC-Tool
software.
Use only the enclosed subwoofer cable for
connecting a speaker (page 34, fig. 2)! The
use of other cables may cause severe harm
to the amplifier and or speaker.
Connecting a passive MATCH Plug & Play sub-
woofer:
1.
Connect the 8-pole Molex connector of the
subwoofer cable (A) to the connection cable of
the MATCH Plug & Play subwoofer. (B).
2.
Next, connect the 2-pole Molex connector of
the subwoofer cable to the
Subwoofer Output
of the amplifier.
Connecting a conventional passive subwoofer
or speaker:
1.
Disconnect the ASIA plug connection of the
subwoofer cable (C).
2.
Afterwards connect the loudspeaker cable
of the speaker (D) to the ASIA round plugs
of the subwoofer cable (E). Ensure that the
loudspeaker systems are correctly connected
(phase), i.e. plus to plus and minus to minus.
Exchanging plus and minus can cause a loss of
bass reproduction. The plus pole is indicated on
most speakers. The impedance of the connect-
ed speaker must not be less than 2 Ohms, oth-
erwise the amplifier protection will be activated.
3.
Connect the 2-pole Molex connector of the
subwoofer cable to the
Subwoofer Output
of the
amplifier.
8.
Connecting the line outputs F - I
The pre-amplifier outputs has to be used for
connecting additional amplifiers.
Attention:
Use only the enclosed Line Output-
to-RCA / Cinch cable for connecting addition-
al amplifiers (page 34, fig. 3). The Augmented
Bass Processing can also be activated for the
output channel Line Out 1 (F) in the standard
signal processing concept of the DSP PC-Tool
software.
9.
Connecting the remote output
This output (
Remote Out
) is used to supply re-
mote signals to additional amplifier/s that are
connected to the
Line Out
of the M 5.4DSP. Al-
ways use this remote output signal to turn on
the amplifiers in order to avoid on / off switching
noises.
A
B
C
D
E
