31
Limited to -30 dB: The volume is set to maximum -30 dB (max. half of the total volume range) when the system is
switched back on, if the volume exceeded the value when it was switched off.
Limited to -45 dB: The volume is set to maximum -45 dB (max. 1/4 of the total volume range) when the system is
switched back on, if the volume exceeded the value when it was switched off.
Application example at 100 % volume level:
Disabled –
Volume after switch
back on (100 %)
Volume level before
switch off (100 %)
Limited to -30 dB –
Volume after switch
back on (50 %)
4.3 CONDUCTOR status
This is where all important information on the CONDUCTOR’s status can be found.
CONDUCTOR communication protocol version: Shows the current version of the communication protocol.
CONDUCTOR firmware version: Shows the currently installed CONDUCTOR firmware. The firmware is automatically
updated when opening the DSP PC-Tool software.
CONDUCTOR operation status:
Shows the CONDUCTOR’s operation status.
4.4 Saving and loading CONDUCTOR settings
This is where the entire configuration of the CONDUCTOR can be saved as a file on the hard disk, because the settings
are not stored in the .afpx file of the DSP PC-Tool.
These settings are saved as a so-called “.afcc”-file (Audiotec Fischer CONDUCTOR configuration) and can be loaded
into any CONDUCTOR-compatible DSP device afterwards.
