As a summary, here is a list of controls and the patch cable connections required for Mode 12:
1.
The external
envelope
generator inputs 1 - 8 need not to be connected (if you have cables already
connected to them, no harm, you can keep them connected, but they have no effect).
2.
If you want to use the PM modulation feature, connect also an envelope generator output to
modulation
2
. Maybe it is best to first try without any connection.
adjust 1
or
adjust 2
do not have
control on the PM modulation sensitivity, therefore the envelope amplitude directly makes the PM.
3.
Use
slider 30
and
adjust 2
to control the speed and inter-envelope delays of the 8 envelopes, and
adjust1 to control the envelope shapes.
4.
Optionally, connect the
CV pitch
and
CV velocity
inputs to the corresponding MIDI input module
outputs.
5.
Keep the toggle switch in the
gate on
-position. If your MIDI interface module does not have the gate
signal connected to the Eurorack bus, use
modulation 1
as the trigger input.
6.
Check the harmonic slider virtual link connections to the
envelope inputs
1 - 8 because they
determine the internal envelope generator delays.
Figure 4: Mode 12 is the only mode that uses an internal envelope generator/sequencer. The three envelope plots
show the effect of
adjust 1
at the two extreme cases (left & right), and in the middle adjusted case for the attack
period of the note. The duration can be adjusted using
adjust 2,
and each of the 30 harmonics will have a similar
copy of the envelope, but with the selection of 8 different possible delay periods from the gate trigger.
21
