Page 21
LIVEtouch20
- 20 Channel Digital Mixing Console
English
5 - Setup
1
2
3
4
5
6
1
- Information
System Version shows the version of APK, DSP, Fader and other software on this console. The IP address indi-
cates the console's IP address.
2 - Sample Rate
The default setting is 48.0 KHz. When you press 44.1 KHz once, a window opens: "The 44.1 KHz sample rate is
only used for digital outputs", then the 44.1 KHz zone turns on and the 48 KHz zone turns off. The default value is
always 48.0 KHz after rebooting the system.
3 - Delay Unit
Selects the unit of measurement for the Delay.
4 - System
- Maintenance: Allows access to the operating system.
- SetupWifi : Allows you to set the Wifi access to the console.
5 - Brightness
Adjusts the brightness of the touch screen.
6 - Crossover
Press BUS 8 IN, the filter works. At this point, the BUS8 operates in low mode. The control knob can be used to
change the cutoff frequency from 40Hz to 300Hz. The filter slope is 24dB/oct.
Press the Master L/R IN button, the filter works. Master L/R output operates in low cut mode. The slope of the
filter is 24dB/oct. The cut-off frequency adjustment range is 40Hz to 300Hz. Using these two filters reasonably
results in a 2.1.
5-1 Setup page
