10
The keys in detail:
Screen page 1:
Use keys
An1
to
An6
to access analog inputs 1 to 6 16 directly. Use keys
D1
to
D5
access digital inputs 1 to 5 10 directly. Press key
Ext. 8ch
to directly select the external
8-channel analog input
ANALOG 8 CHANNEL INPUTS
11. See back panel layout to
find corresponding input jacks.
Screen page 2:
Press key
PCM direct
to enter PCM Direct Mode. In the display the input channel name
is replaced by '
-PCM direct-
'.
Note:
You can only activate PCM Direct Mode, if a stereo PCM signal is available at
the current input (and if you are not using the HighBit interface). While in PCM Direct
Mode, the internal decoder (and therefore Bass Manager, any matrix decoding etc.) is
deactivated temporarily in order to playback stereo PCM material purely and without
any changes. To leave PCM Direct Mode, press
PCM direct
again. If a signal other than
stereo PCM is detected at the current input, PCM Direct Mode is switched off
automatically. The display will inform the user with the message
'PCM direct
off'
.
Press key
Dyn. Range
to enter '
Dynamic Range
' menu. Use keys
and
to select
desired dynamic range.
Maximum:
full dynamic range, no compression at all
Standard:
medium dynamic range, moderate compression
Minimum:
minimal dynamic range, full compression
Note:
This menu is only available, if
'Internal Decoder'
is set to
'active'
.
Press key
Monitor
to toggle monitor/effects loop
MONITOR IN / OUT
18. This loop
works for Front channels L/R only. It enables you to listen to a recorder without
interrupting the signal source being recorded or inserting effects processors like
equalizers etc. Connect
MONITOR OUT
to processor inputs and
MONITOR IN
to
processor outputs.
Press key
Dolby PL IIx / DTS Neo:6
to enter
'Decoder Setup'
menu. Here you select the
desired mode for Dolby Pro Logic IIx and DTS Neo:6 decoding. Additionally, you
choose between Dolby Pro Logic IIx or DTS Neo:6 processing on Stereo PCM signals
in Listening Modes '
Audionet D8
','
3 Stereo
' or '
Phantom
'. For a more detailed
description refer to chapter
'Preferences / Setup'
, section
'Decoder Setup'
.
