21
Note
·
In case of thermal overload the AMP VII will always switch off in-
dependently from the display setting.
·
The temperature display mode gives the user a clue about the thermal
load of the AMP VII. It depends on the placement, air flow and cool-
ing, surrounding temperature and the number of installed modules in
the AMP VII. Nevertheless, the full musical performance is achievd
even if the display reports
Temperature Cool
.
8.3 Set Input
The user can select the input for all modules simultaneously or individu-
ally. First, navigate to menu item
Select Module
and enter the sub
menu
SET INPUT FOR
with a long keystroke on the
power
key.
Now use short keystrokes to select the module whose input you would
like to configure:
all Amp Modules
Use this setting if you would like to configure
the input for all modules simultaneously. All
modules will be set to the same input after the
following configuration.
Amp Module No. x
Select the module whose input you would like
to configure individually. The input settings of
all other modules are not affected after the fol-
lowing configuration.
Acknowledge the module selection with a long keystroke of the
power
key on the front panel. The AMP VII enters the sub menu
Set Input
.
Now select the desired input:
Line (Cinch)
Select this option if you connected your re amplifier
to the Cinch input of the module.
Balanced (XLR)
Select this option if you connected your pre ampli-
fier to the balanced (XLR) input of the module.
do not change
Select this option if you would like to exit the menu
without any change. This option is only available if
you selected
all Amp Modules
before and not all
modules are set to the same input.
Summary of Contents for AMP VII
Page 1: ...1 Modular Multichannel Power Amplifier User s Manual...
Page 2: ...2...