Audionet AMP VII, User Manual, Page: 12 / 27

12
Note
·
Look out for the correct connection of your speaker cables. Usually
the terminals of your speakers are marked '+' and '-'. The AMP VII
uses the same marks.
·
Wrong speaker polarization will result in severe loss of sound quality!
Important
·
Although the AMP VII has an effective protection system to pre-
vent damage to the circuits, switch off the unit while working on
the speakers and/or audio cables.
·
The nominal loudspeaker impedance should be 2 Ohms or higher.
·
Never use force or tools tightening the terminal screws.
Tip
·
If your speakers support bi-wiring, use two separate cables to connect
each speaker to the AMP VII. Impulse response and spatiality my
improve significantly.
Note
·
Again, please mind the correct polarization of the speakers!
5.3 Audionet Link
For your convenience, the AMP VII can be controlled remotely by one of
Audionet's multichannel pre amplifiers (e.g. MAP or MAP 1) as well as
one of Audionet's stereo pre amplifiers (e.g. PRE or PRE 1) using the
'Audionet Link' interface.
You only need a simple optical 'Toslink' cable to connect the 'Audionet
Link' output of your Audionet pre amplifier to the 'Audionet Link' input
link IN
26 of the AMP VII.