Audionet AMP VII, User Manual, Page: 16 / 27

16
minutes in steps of 15 min. The following diagram explains the possible
countdown timer settings:
0 1 hour 15 min 0 1 hour 15 min 01 hour 15 min
1 1 hours 15 min 0 2 hours 15 min 01 hour 30 min
9 1 hours 15 min 0 0 hours 15 min 01 hour 00 min
10-hours setting 1-hour setting minutes setting
long keystroke short keystroke
Activate the countdown timer by leaving the timer setup menu with a
long keystroke. Alternatively, the countdown is started automatically if
you do not change any settings for longer than 12 seconds.
Note
·
While the countdown is running, the display shows the remaining
time until automatic start-up:
WARM UP IN :
02 hours 43 min
·
If the display saver is active, the display shows the remaining count-
down time abbreviated (e.g.
02:43
). Please refer to section ' Set Dim
Level ' on page 20 for detailed information on the display saver.
If you would like to use the countdown timer again, simply activate it by
a long keystroke: While in stand-by mode press the
power
key longer
than 2 seconds and wait. After 12 seconds the countdown will start again
with the previous programmed time.
To de-activate a running countdown just press the power key for less
than 2 seconds at any time.