![Audionet AMP V User Manual Download Page 22](http://html.mh-extra.com/html/audionet/amp-v/amp-v_user-manual_3012120022.webp)
22
Note
·
Due to security concerns the Auto On function will only be available
after first manual switching on.
·
Because of the nature of stereo or multi-channel signals it may occur
that the AMPs in your setup will switch on at a different point of time
according to each input signal.
·
Operate the AMP as usual. Of course, you still be able to switch
on/off the unit manually
8.5 Set Auto Off
The AMP will power down automatically (Auto Off function) when no
input signal is detected for a user selectable amount of time.
Select the desired time to shut down:
never off
Select this option if you would like to de-activate the
Auto Off function. The AMP will not shut down
automatically if no signal is detected. You have to
power down the unit to stand-by mode manually.
off in 30 secs
If no input signal is detected for 30 seconds the
AMP will shut down automatically.
off in 5 min
After 5 minutes without an input signal the AMP
will shut down.
off in 15 min
After 15 minutes without an input signal the AMP
will shut down.
off in 60 min
After 1 hour without an input signal the AMP will
shut down.
off in 120 min
After 2 hours without an input signal the AMP will
shut down.
8.6 Set AutoStart
If the AutoStart function is active, the AMP starts up automatically to
normal operating mode right after the unit is connected to mains power
(e.g. by operating the mains switch 9 on the back panel). Use this option
to start up the AMP automatically using a timer device.
disabled
The AutoStart function is de-activated. If you connect the
AMP to mains power, the unit will start up to stand-by
mode. To activate the AMP use the
power
key on the