12
5.5 Audionet Link
For your convenience, the AMP1 V2 can be controlled remotely by one
of Audionet's multi channel pre amplifiers (e.g. MAP or MAP 1) as well
as one of Audionet's stereo pre amplifiers (e.g. PRE G2, PRE 1 G3) using
the Audionet Link interface.
You only need a optical 'Toslink' cable to connect the Audionet Link
output of your Audionet pre amplifier to the Audionet Link input
IN
3
of the AMP1 V2.
In case you would like to automatically switch on/off further Audionet
units in your system (e.g. a second AMP1 V2) using the Audionet Link
interface, please connect the Audionet Link output
OUT
4 of your
AMP1 V2 to the Audionet Link input of the next Audionet unit (e.g.
power amplifier, tuner, CD player etc.) using a simple 'Toslink' cable.
Note
·
The 'switch on' signal is issued to any further Audionet units daisy
chained to the Audionet Link output of your AMP1 V2 with a little
delay to avoid all units switching on at the same moment, which
could cause an overload of your mains fuse.
