10
5 Inputs and outputs
Important
·
For connecting or removing loudspeakers and/or the pre ampli-
fier your AMP1 V2 must be switched off to prevent damage to
the amplifier or the connected units.
·
Please make sure that all cables are in absolute best conditions!
Broken shields or short-cut loudspeaker cables could damage
speakers and/or amplifiers.
5.1 Inputs
The AMP1 V2 has two RCA inputs 1 and 8 for the connection of a pre
amplifier, e.g. Audionet PRE G2. Due to the dual mono construction, left
and right inputs are separated at the rear.
Please connect the right 1 and left input 8 of the AMP1 V2 to the cor-
responding outputs of your pre amplifier.
5.2 Speaker terminals
Connect your speakers to the gold plated terminals 2 and 7 on the back
panel of the AMP1 V2. You can use banana plugs or spades as well as
simple cable ends. In case you would like to bi-wire your speakers please
refer to section '
Bi-Wiring
' on page 11.
Note
·
Look out for the correct connection of your speaker cables. Usually,
the terminals of your speakers are marked '+' and '-'. The AMP uses
the same marks.
·
Wrong speaker polarization will result in severe loss of sound quality!
Important
·
Although the AMP1 V2 has an effective protection system to pre-
vent damage to the circuits, switch off the unit while working on
the speaker and/or audio cables
.
