P. 14
AUDIOLAB Live Snake 16.8 -
7. TROUBLESHOOTING
Note:
The supplier will not assume responsibility for errors or omissions in the manual. The information
in this manual is subject to change without prior notice.
English version
Problem
Possible Cause
Suggested Solution
Power light doesn't on after the
device powered on.
The power outlet or power strip
is not working.
Try a different outlet or power
strip.
Power cord is malfunctioning.
Replace the DSS power cord.
Ethernet green LED does not
work after plugging a DSS to a
router.
The router isn't powered on.
Power in the router.
The Ethernet cable is broken.
Try a different cable.
The port on the router not work.
Try plugging the cable into a dif
-
ferent port on the router.
The DSS can not be controlled by
the DSS discovery software.
There is no Network Interface
Card (NIC) used to connect to the
CobraNet network.
Select the card to serve as the
network adapter used in the dis-
covery process from the Network
Adapter.
The DSS is not in the PC control
status.
Set the first three switches of
the DIP switch which on the rear
panel down.
The green LED of Ethernet port
lights on but without output.
No signal route to the transmitter.
Make sure the transmitter inputs
signal.
The output channel of the receiv-
er is not assigned signal.
Make sure the output channel of
the receiver has assigned signal.
The transmitter's Tx bundle
number and receiver's Rx bundle
number are different.
Make sure the bundle numbers
of them are the same.
The Subcount number is less
than the channel number of the
receiver which you are using.
Set the Subcount number no less
than the channel number which
you want to use.
The value of modeRateControl
for the receiver and transmitter
are different.
Make sure the values of mode
Rate Control of the receiver and
transmitter are the same.
