15
Installation Manual
Subwoofer Amplifier
RS 500
17.
IR in
– if you want to control the
volume of the RS amplifier with an
infra-red remote control, use this port
to connect a powered wired IR sensor
to the amp. You can teach the amp to
listen to IR control or you can use the
default codes located in the automa-
tion table on the RS amplifier web
page at www.audiocontrol.com .
18.
AC Input –
Connect the supplied AC
power cord securely to this input. Plug
the other end into an AC mains outlet
of the correct voltage rating for your
unit. This unit is a class 1 device, do not
defeat the safety ground connection
or use a power cord that does not have
the safety ground pin.
19.
AC Fuse
– The main power supply fuse
may be checked or replaced. Make
sure that the power cord is unplugged
from the AC mains first. Then use a
flat-headed screwdriver to undo the
fuse carrier from the fuse holder.
Inspect the fuse and replace with the
exact same type indicated on the unit.
The use of any other type of fuse may
lead to an unsafe condition. If the fuse
blows again immediately, then unplug
the power cord and contact our fine
folks in customer service. Do not open
the unit, as there are no user-ser-
viceable parts inside, and dangerous
voltages exist.
Almost Done With The Rear Panel
20.
AC Power Switch –
This switch shuts
off the main AC power. Normally the
only time you need to turn this off is
if the system is going to be shut down
for an extended period of time. Use
the Ethernet or master trigger inputs
to switch the unit between standby
and on.
Also turn the power switch off during
lightning storms, wind storms with
frequent power outages, or when a
giant asteroid is heading to the power
station again.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
