AudioControl DQDX, User Manual, Page: 6 / 32

----------------------------------------------- 6 -----------------------------------------------
5.
Connect your amplifier trigger input to the 12-volt trigger output
of the DQDX.
6. VERY IMPORTANT! Make sure the input gain control on your
aftermarket amplifier(s) are all the way down (usually counter
clockwise).
7. Turn on the system and level match your DQDX to your source
unit and amplifiers.
8.
Select the correct crossover point on your DQDX to create a Hi-
Pass for the front and rear outputs and a Low-Pass for your sub-
woofer output, if you are not using the crossover on your source
unit. We would always recommend turning the crossovers OFF
on your source unit and using the sweet crossover in the DQDX.
9.
On the chassis of the DQDX, set Signal Delay Mode to Set-Up.
10.
Using the ACR-3 Dash Control, adjust the signal delay between
the Left and Right channels for optimum sound.
11. Tap the ACR-3 Dash Control and adjust the signal delay between
the front and subwoofer outputs.
12. On the chassis, change Signal Delay Mode back to Normal.
13. Set the equalization controls for the front, rear, and subwoofer
channels. While your ears are a good reference point, we recom-
mend using an audio analyzer whenever possible. To engage the
pink noise output of the DQDX for help setting up the equalizer,
press and hold the ACR-3 remote knob down for about four
seconds. This will switch the outputs of the DQDX from music
to Pink Noise. When you are done setting up the Equalizer, you
can just press and hold the remote again for 4 seconds and it will
turn the Pink Noise output off.
14.
Sit back and enjoy the sound