- 4 -
A10-RX User Guide
System Quickstart
The A10 Digital Wireless System is easy to use Follow the steps below for basic setup and oper-
ation
At the Receiver
1 Fit the included straight and right-angled antennae to the A10-RX receiver
2 Connect the receiver to a power source It will immediately power on
3
Using the scanning tool in the Selection menu find an available open frequency. If multiple
wireless systems are in use, make certain to keep frequencies least 400 kHz apart.
4 Connect the audio output from channel 1, channel 2, or both to an audio input on a mixer,
recorder, camera, or PA system
5 Ensure that the receiver audio output type and level are set based on the input type
At the Transmitter
1 Attach the straight antenna to the A10-TX
2 Attach an audio source to the 3-pin LEMO input connector
3 Insert AA batteries into the A10-TX battery compartment and power on the unit with the red
On/Off button.
4 Set the audio input type to set to match the connected input
5
Set the transmitting frequency on the A10-TX match the frequency set on the A10-RX re
-
ceiver channel
6 Adjust the audio gain according to your environment and source, taking care not to overload
the signal This is indicated by a red LED
At the Receiver
1
Confirm that the Channel Power LED is solid blue.
2
Confirm that the RF Status LEDs and display indicate good RF strength.
3
Confirm that the audio level at the receiver corresponds to the audio connected to the
A10-TX input
4 The system is now ready for use
