P.8
-
Replace only with fresh, new batteries.
-
If unit will not be used for a long period of time, remove batteries to prevent damage
or injury due to possible battery leakage.
-
Keep all batteries away from children.
7.
You should now be able to place the speakers freely from room to room without
disruption. Should there be any disruption (signal cuts off or carries distortion), press
the speaker’s “AUTO TUNE” button to maximize the best reception.
If you hear interference from other components, move the speakers to another free
location, then re-adjust the tuning control by selecting different Channels of the
transmitter, then press the “AUTO TUNE” button on Speakers for best reception. When
transmitting / receiving over long distances, the signal from the system will become
weaker.
8.
Switching Off
a.)
For protection of the transmitter and power saving, the transmitter will cut off
automatically if there is no/weak operation input signal from the audio source for
4 minutes.
In other words, if the signal comes back, the transmitter will work again
automatically
b.)
When the speaker is turned off by pressing the Power button on the speaker all
power to the speaker and remote control sensor will turn off. The speaker will
not respond to any commands from the remote control. If the remote control
Power button is used while the speakers are powered on they will be put into at
stand-by mode for 5 minutes, the speaker power LED will change from blue to
yellow. Pressing the remote control Power button during the stand-by time will
restore full power to the speakers, the speaker power LED will switch from
yellow to blue. If there is no signal from the remote control unit in 5 minutes, the
speakers will automatically power off, the power LED will not be lit. The remote
will not power up the speakers from the powered off state.
P.9
TROUBLE SHOOTING
NO SOUND
-
Ensure the AC/DC adapter is fully inserted into the AC outlet and the
power connection input on the transmitter.
-
Ensure the speakers are switched ON.
-
Speaker’s batteries are drained or capacity is too low. Replace with new batteries
or connect the AC/DC adapters to the speakers.
-
Transmitter’s batteries are drained or capacity is too low. Replace with new batteries
or connect the AC power adapter to the transmitter.
-
Ensure the TV or audio component is ON.
-
The connected audio / video equipment is not playing. Start playing the equipment.
-
The volume of speakers is too low, adjust the volume to an appropriate level.
-
The volume of the audio source is too low. Turn up the volume of the source
equipment (iPod, radio, etc.).
DISTORTED
-
Press the “AUTO-TUNE” button on the speakers until you have matched the
frequency of the transmitter.
-
Change the position of the channel selector on the transmitter. You must then press
the “AUTO TUNE” button on the speakers.
-
Speaker’s battery capacity is too low. Replace with new batteries or connect AC
power adapter.
-
Transmitter’s battery capacity is too low. Replace with new batteries or connect AC
power adapter.
-
Ensure the volume level of speakers is adjusted properly.
-
The speakers are too far away from the transmitter, move it closer.
-
The input level of the audio signal is too low. Turn up the volume of the audio source
equipment..
-
The audio input level of the transmitter is too high, lower the volume of the audio
source equipment.
