P.8
WARNING:
The Power adapters are for indoor use only.
If it is wet outside or raining, you can
continue to operate your speakers via their internal batteries. Please move the adapters
out of the rain by removing them and placing them in a safe dry place.
.
When powering by AC household current this device must be used with the AC/DC
adapters supplied within the package. Do not try to power using other AC or DC
adapters.
This device must be used with the AC/DC adapters supplied in the package.
TROUBLE SHOOTING
NO SOUND
-
Ensure the AC/DC adapter is fully inserted into the AC outlet and the power
connection input on the transmitter.
-
Ensure the speakers are switch ON.
-
Speaker’s battery capacity is too low, replace with new batteries or connect
the AC/DC adapters to the speakers.
-
Ensure the TV or audio component is ON.
-
The connected audio / video equipment is not playing. Start playing the
equipment.
-
The volume of speakers is too low, adjust the volume to an appropriate level.
DISTORTED
-
Press the “AUTO-TUNE” button on the speakers until matching the frequency
of the transmitter.
-
Change the position of the channel selector on the transmitter. You must then
press the “AUTO TUNE” button on the speakers.
-
Battery capacity is too low. Replace with the new battery.
-
Ensure the volume level of speakers is adjusted properly.
-
The speakers are too far away from the transmitter, move it closer.
-
The input level of the audio signal is too low. Turn up the volume of the audio
source equipment.
P.9
TECHNICAL SPECIFICATIONS
Transmission Mode
: UHF
Carrier Frequency
: 900 MHz Digital Hybrid
Operation Voltage
: Transmitter, DC 12V 150mA
Speakers, 6x ‘C’ size Alkaline batteries or DC 9V 1A adapter
Remote Control Unit, 2 X ‘AAA’ size batteries
Frequency Response : 40Hz – 12KHz
Distortion :
1%
S/N Ratio
: 65dB (typical)
Operation Distance
: Up to 150 feet
Speakers
:
2-way
Output Power
: 2 x 5 Watts
NOTE:
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
