P.6
NOTE :
a) Keep the speakers up to 7 meters apart from the transmitter, and then press
“AUTO TUNE” button for the best reception.
b) Should you experience any frequency interference, move your channel switch
from one channel to the other channel (there are two channels for selection) on
the transmitter, and then press the “AUTO-TUNE” button again.
5. When the batteries are installed your speakers are portable and can be carried freely
from room to room (and outdoors) up to their maximum range. Should you
encounter any sound disruption (signal cuts off or carries distortion), press the
speaker’s “AUTO TUNE” button to maximize the best reception.
If you hear interference from other components, switch on the channel control of
transmitter, and then move the speakers to another location. You can re-adjust the
tuning control by changing it to either channel 1 or 2 on the transmitter and by then
pressing the "AUTO TUNE" button, for best reception.
P.7
When transmitting / receiving over long distances, the signal from the system will
become weaker. This system will transmit through walls, floors and other obstacles.
However, range will be maximized by the “line of sight” placement with no obstacles
between the transmitter and the speakers. Keep this in mind when placing your
equipment throughout your house.
6. Switching
Off
a) To protect the transmitter and save power, the transmitter will turn off
automatically if it detects that the unit is not being operated or, there is weak
reception from the signal audio source, for 4 minutes.
In other words, if the signal comes back, the transmitter will work again
automatically.
b) Press the ON/OFF button to turn off the speakers and the LED light will then
turn off, or simply press the ON/OFF button on the remote control unit. If you
use the remote control unit to turn off the
speakers, the speakers will
be at
stand-by mode for 5 minutes and the LED will change from blue to yellow. You
can switch on the speakers again by using the remote control unit during the
stand-by time. If there is no signal from the remote control unit in 4 minutes,
the speakers will automatically power off.
ATTENTION:
The transmitter for this speaker set is designed to work with a wide variety of devices.
Our tests have shown the default volume levels of iPods, MP3 players and other devices
connected to the transmitter through the headphone jack does not have the signal
strength required by the transmitter. Raising the volume of your device will increase the
signal strength to the transmitter. The blue signal LED will light when the required signal
strength from your device if reached. We recommend that you keep the volume set on
your iPod or MP3 player at a minimum of ¾ of full volume.
