typically take no more than 5 seconds.
4. If the audio source connected to the transmitter is turned off for less than 4 minutes, the BLUE
lights on the transmitter and the speaker remain on, but no sound is transmitted. When the audio
signal is turned back on, sound is transmitted again.
5. If no signal is detected for more than 4 minutes, the transmitter automatically turns off and goes
into STANDBY mode. The BLUE lights on the transmitter and the speaker switch to GREEN.
6. If no audio signal is detected from the transmitter for more than 15 minutes, the speaker
automatically turns off. The GREEN LED goes off.
7. To turn speakers on, press the POWER button on the front panel of the speaker for 3 seconds.
8. To turn the speakers off, press the POWER button on the front panel for 3 seconds.
PAIRING
1.
PAIRING is needed when 2 or more speakers are being used with the same audio source.
2.
Press the ‘Pair’ button on the transmitter and the ‘Light/Pair’ button on one of the speakers for 5
seconds there will be an audio test tone when the pairing process is finished.
3.
The first speaker is now paired and memorized by the transmitter.
4.
Repeat the procedure on the second speaker by pressing the “Pair” and the “Light/Pair” button
on the transmitter and the second speaker respectively.
5.
Repeat this procedure on any additional speakers.
Blue Mood Light
For mood light effect, press the LIGHT button on the speaker or remote control.
Left / Right Channel and Mono Selection
The SPK-24GX-DUO Wireless Speaker System comes with two speakers and is designed for either
Mono or Stereo playback. Mono playback is suggested when each speaker is used in a separate
area or room. The transmitter supports up to a total of 6 speakers in stereo or mono modes.
Mono Playback
To enable Mono playback, ensure that the switch located on the back panel of the speaker is in the
MONO position.
Stereo Playback
To enable Stereo playback, set the switch on one of the two speakers' back panel to LEFT. Set the
switch on the other speaker to RIGHT.
Note 1:
It is also possible to listen to only the Left or Right audio channel using only the speaker set.
To do so, simply set the switch on the speaker's back panel to LEFT or RIGHT. Only the channel
selected will be audible.
Note 2:
If two speakers are connected to the system, ensure both speakers are placed within the
