Specifications
Transmission Mode: UHF Stereo
Carrier Frequency:
2.4GHz Digital
Operation Voltage:
Transmitter, DC 6V 2A
Speaker, DC 12V 1.5A or 6 x D alkaline batteries (not included)
Remote Control, 1 x CR2032 button cell
Frequency Response:
30 Hz – 20 KHz
Distortion: 0.5%
S/N Ratio:
65 dB
Operation Distance:
Up to 50 meters (open area)
Speaker Audio Output Power: 20W Max. (RMS)
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
ATTENTION:
The transmitter for this speaker set is designed to work with a wide variety of devices. Our
tests show the default volume levels of iPods, MP3 players and other devices connected to
the transmitter through the headphone jack does not have the signal strength required by
the transmitter. Raising the volume of your device will increase the signal strength to the
transmitter. The blue signal LED will switch from flashing to steady when the required
signal strength from your device is reached. We recommend that you keep the volume set
on your iPod or MP3 player at a minimum of ¾ of full volume.
FCC COMPLIANCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
“NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
