Studio Broadcast System
Page 7 of 11
3.
Positioning
When wearing the bodypack transmitter, is it important to remember that the
front of the unit (the portion on which the display and controls are located)
contains the unit’s antenna. This antenna requires a clear path to and from the
rp32 receiver in order for the unit to operate properly.
Place the display side (front side) of this bodypack transmitter facing out, and not
directly against or towards a body or other solid object.
Specifically, the antenna is located directly under the Audio-Technica logo on the
front of this unit. Holding or continuously touching the logo directly over the
antenna may de-tune the unit and negatively affect performance.
4.
System QUICK START
Using a shielded CAT 5 cable (may be used with up to 1,000 feet of cable per
channel) terminated with a standard RJ45 connector, plug the cable into the RJ45
input jack on the rear of at least RP32 receiver. Connect the other end of the CAT
5 cable to the RJ45 input jack on the rear of the MCU3224 main control unit. You
may connect up to 32 RP32 receivers by connecting them into the corresponding
channel output (1-32) found on the rear of the MCU.
You do not need to turn the RP on. It receives power via the CAT 5 cable
from the MCU 3224. The RP display should immediately light and display
the channel output number to which it has been connected on the MCU.
