17
Display Brightness
The display brightness feature offers
six different settings (including off) for
the vacuum fluorescent display on the
front panel. When the lowest setting
(off) is selected, the display will remain
on for five seconds after any button is
pushed, after which it will revert to a
black screen with a small, illuminated
square in the center to indicate the unit
is powered on. To change the display
brightness, press the ‘MENU’ button
until ‘DISPLAY BRIGHTNESS’ appears.
Press the enter button. Using the volume
knob on the front panel, or the up/down
volume buttons on the remote, change
the display brightness to your preference.
Once you have selected the appropriate
brightness, there is no need to press
‘ENTER’ or any further buttons.
Note
The remote control offers direct control
of the display brightness via two buttons
labeled ‘DISP UP’ and ‘DISP DN’. You
can choose to use these buttons as an
alternate to the settings menu.
Volume Reset
The volume reset feature tells the LS28SE
to either remember the volume settings
for each individual input, or to reset them
to zero after a power off cycle. When
volume reset is set to ‘OFF’, the LS28SE
will also remember settings after a power
cycle. To change the status of the volume
reset, press the ‘MENU’ button until the
display reads ‘VOLUME RESET’. Press
‘ENTER’, and use the volume knob on
the front panel, or the up/down volume
buttons on the remote, to select ‘ON’
or ‘OFF’. Press ‘ENTER’ to choose the
appropriate setting, and ‘ENTER’ once
again to confirm. The display will read
‘OKAY’ and show the current setting for
volume reset.
Input Naming
The LS28SE is pre-loaded with a selection
of names which can be assigned to the
eight inputs of the preamplifier, allowing
for easier identification of the various
inputs. When selected, the chosen input
name will display above the default name
(BAL 1, SE 3, etc.) on the normal operation
screen. To select an input name for any of
the inputs, press the ‘MENU’ button until
‘INPUT NAMING’ is displayed. Press the
‘ENTER’ button, and use the volume knob
on the front panel, or the up/down volume
buttons on the remote, to select the
desired input for naming. Press ‘ENTER’ to
engage the naming utility, and using the
volume knob or up/down volume buttons,
select the appropriate name for the input.
Press ‘ENTER’ a final time to confirm the
input name. The display will show ‘OKAY’.
Summary of Contents for ARCLS28SE
Page 1: ...H I G H D E F I N I T I O N LS28SE...
Page 2: ...There is only One Reference...
Page 21: ......
