Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Procedure:
– Connect vehicle diagnostic tester
– Select
Diagnosis
mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v
and press
Apply
.
– Switch to “Special functions” tab.
– Select service setting to be reset (e.g. “17 — Inspection”).
– Start program by selecting
Carry out check
.
– Continue to follow instructions on screen.
Note
Please refer to the relevant Maintenance table for information on
which service channel to reset and what data to enter.
3.4
Transport mode: deactivating
WARNING
Risk of injury as engine of high-voltage vehicle can start un‐
expectedly!
♦ Observe warnings for high-voltage system:
♦ For work that must be performed with the ignition switched
on
Procedure:
– Connect vehicle diagnostic tester
– Select
Diagnosis
mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v
and press
Apply
.
– Switch to “Special functions” tab and select following program:
♦ 19 - Activating / deactivating transport mode
– Start program by selecting
Carry out check
.
– Continue to follow instructions on screen.
Note
♦
The transport mode serves to maintain the vehicle's ability to
start.
♦
When the vehicle is in transport mode, many functions, e.g.
radio, are restricted or unavailable.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
3. Maintenance
27
